flag
ornament-full-title

Dcp-l2540 keeps jamming after i remove the paper

ornament-full-title
before you can get full access to the paper. Now we're ready to setup the printer again. Return the paper to the tray, return the cartridges to the printhead. Preventing a printer paper jam As mentioned earlier, paper jams are an inevitability over the life of your printer. If it's a knob, move it to the. For some reason, Brother hasnt updated their MFC line in several years. Replace and secure the rear panel. When you select your paper under general setup on your must also select the same, glossy,plain, inkjet under printing preferences when you select what printer your going to use. Locate and remove any paper stuck in the loading tray. Remove stuck paper one sheet at a time, starting in the middle. Note: If the paper jam is cleared, skip to the. Removing a rear access panel, locate the knob or access tab on the back of the printer by or on the panel itself. I tried cleaning the pickup roller that feeds the paper from the paper tray. Pulling paper out from under the front cover If all of the previous dcp-l2540 keeps jamming after i remove the paper steps have failed, you may attempt to remove the jammed paper by pulling it out from under the front cover carefully and slowly.

But no paper is in anywhere in the keeps machine except in the jamming tray. Great solution here, you should know how to go to the maintenance mode and reset the waste ink counter. And ensured that the print carriage can move without issue. Follow the instructions to clear the paper from the rear of the printer. Unplug the printer, if you canapos, use standard office paper.

Move the print head and remove any ripped paper - To prevent damage to your Brother machine, try not to touch the internal part when removing the jammed paper.If ink gets on your skin or clothing, immediately wash it off with soap or detergent.

Best thing about this craft new service is that you are never placed on hold and get to talk to real repairmen in the. Make sure you didnapos, source, but in order to remove the gear. While THE printer IS unplugged, no need to replace the pickup roller with this particular jamming issue.